STEP 1 - The Old Grip
Install Sniper Skin Grip over the old grip or Remove it...
STEP 2 - Fit Foam To Fingers (optional)
Install the Repositionable Foam Tape to make a spiral around the handle
Test finger fit by placing them inbetween foam Tape
- Reposition foam tape until satisfied
STEP 3 - Position on Handle
-Orientate Sniper Skin with the
SS Logo Band near the shoulder
-Slide into place
-The extra will be trimmed in step 5
STEP 4 - Form Grip - HEAT GUN
Requires a Heat Gun. No heat gun, move to Step 4 - BOILING WATER
Start at the shoulder
-Position heat 6 in. from Sniper Skin
Apply high heat evenly by rotating the paddle 360 degrees
Apply heat moving upward until shrink is complete
STEP 4 - Form Grip - BOILING WATER
-Boil 1.51 of water
(Boiling Water = 212ºF or 100°C)
Position grip down, rest on sink bottom
Pour boiling water directly into the top of the iniper Skin until skrink stops,
•Rotate the Paddle to the opposite side, repeat pouring water into sleeve until shrink is complete
-If shrink is incomplete, more heat is needed, repeat steps above.
STEP 5 - Trim off Excess Material
-Use sharp scissors to trim off the extra
material until flush with handle.
-To create a smooth finish, Re-heat the trimmed area, press against a hard, heat resistant surface.
WARNING:
Allow Grip too cool before touching.
Allow water to dry before use.
Check out our installation tutorial
CAUTION: USE AT YOUR OWN RISK
